Skip to content
SPSDPSPlanning & Building Tools

AC Size Calculator (Approximate Tonnage)

Get a rough starting estimate of air conditioner tonnage from room area, sun exposure and occupants.

A common rule of thumb; real figure varies by climate and building.

%

Your results will appear here

Check the inputs on the left and press Calculate. Every result shows its working so you can verify it.

About this calculator

Cooling need depends on area, sun, ceiling, windows and people. This gives a rough starting estimate using an editable area-per-ton figure.

Who should use it: Homeowners, DIY builders and contractors planning a project.

Formula used

  • Tons = area / sq ft per ton x (1 + extra %)
  • Add a small allowance for occupants above two

Worked example

A 14 x 12 ft bedroom with 2 people.

Estimated need

1.4 tons

Nearest standard size at or above

1.5 tons

Detailed results
Room area168 sq ft

How this was calculated

  1. 1Estimate: 168 sq ft / 120 x (1 + 0%) + occupants

Rule-of-thumb estimate. Confirm with a qualified professional or the product data sheet.

A proper heat load calculation by an HVAC professional is more accurate, especially for large or sunny rooms.

How to measure

  • Measure the room area.
  • Note sun exposure and the floor.

Assumptions and limitations

  • Area-per-ton is a rule of thumb, editable.
  • Standard sizes vary by brand.

This tool gives a planning estimate of quantities. It is not a structural, electrical or engineering design. Confirm important decisions with a qualified professional and your product data sheets. Read the full disclaimer.

Frequently asked questions

Is bigger always better?

No. An oversized AC cycles on and off and cools poorly. Match the room.