Concrete Block Calculator
Estimate concrete or hollow blocks and mortar for a wall from its area, block size and thickness.
Your results will appear here
Check the inputs on the left and press Calculate. Every result shows its working so you can verify it.
About this calculator
Blocks are larger than bricks, so far fewer are needed per square metre. This calculator uses the same masonry method with block size presets.
Who should use it: Homeowners and contractors building boundary or partition walls.
Formula used
- Blocks = wall volume / ((l + j)(w + j)(h + j))
- Mortar = wall volume - blocks x l x w x h
Worked example
300 sq ft wall using 400 x 200 x 200 mm blocks, 200 mm thick.
Blocks to buy (with wastage)
324 pieces
Mortar cement
4 bags (50 kg)
Mortar sand
0.7 m3
| Blocks without wastage | 309 pieces |
|---|---|
| Wall volume | 5.57 m3 |
How this was calculated
- 1Wall volume: net area x thickness = 5.574 m3
- 2Blocks count: volume / unit volume with joint = 308.3
- 3Mortar: wall volume - blocks volume = 0.642 m3 wet
This estimates materials only. Load-bearing walls must be designed by a qualified engineer.
How to measure
- Deduct door and window openings.
- Check block size with your supplier.
Assumptions and limitations
- Block sizes are nominal.
- Hollow blocks are counted as full volume, so mortar is a slight over-estimate.
This tool gives a planning estimate of quantities. It is not a structural, electrical or engineering design. Confirm important decisions with a qualified professional and your product data sheets. Read the full disclaimer.
Frequently asked questions
Can I use this for hollow blocks?
Yes for the block count. Mortar will be slightly overestimated because hollow cores are not subtracted.
References
- Block manufacturer's size data. Dimensions vary between producers.